Saturday, October 1, 2011

Retaining wall design-Definition & types

                       Definition: a retaining wall is a structures built in order to hold back earth which would otherwise move downwards. The purpose of a retainin wall  is to stabilize slopes and provide useful areas at different elevations (e.g. terraces for agriculture, buildings, roads and railways).

               The most important consideration in proper design and installation of retaining walls is to recognize and counteract the fact that the retained material is attempting to move forward and downslope due to gravity. This creates lateral earth pressure behind the wall which depends on the angle of internal friction (phi) and the cohesive strength (c) of the retained material, as well as the direction and magnitude of movement the retaining structure undergoes.
                  Lateral earth pressures are zero at the top of the wall and - in homogenous ground - increase proportionally to a maximum value at the lowest depth. Earth pressures will push the wall forward or overturn it if not properly addressed. Also, any groundwater behind the wall that is not dissipated by a drainage system causes hydrostatic pressure on the wall. The total pressure or thrust may be assumed to act at one-third from the lowest depth for lengthwise stretches of uniform height.
Unless the wall is designed to retain water, it is important to have proper drainage behind the wall in order to limit the pressure to the wall's design value. Drainage materials will reduce or eliminate the hydrostatic pressure and improve the stability of the material behind the wall. Drystone retaining walls are normally self-draining.
          A proper  retaining wall design to ensures stability against overturning, sliding, excessive foundation pressure and water uplift, critereas that are insured  by designing them  for a minimum safety factor in static conditions of:
  • 1.3 against lateral sliding and  
  • 1.5 for overturning;
and a minimum safety factor in sesimic conditions of:
    • 1.1 against lateral sliding
    • 1.3 for overturning.
                   Every retaining wall supports a “wedge” of soil. The wedge is defined as the soil which extends beyond the failure plane of the soil type present at the wall site, and can be calculated once the soil friction angle is known. As the setback of the wall increases, the size of the sliding wedge is reduced. This reduction lowers the pressure on the retaining wall.The basement wall is thus one form of retaining wall.However, the term is most often used to refer to a cantilever retaining wall, which is a freestanding structure without lateral support at its top.Typically retaining walls are cantilevered from a footing extending up beyond the grade on one side and retaining a higher level grade on the opposite side. The walls must resist the lateral pressures generated by loose soils or, in some cases, water pressures.
                       Retaining wall types:

    For an advanced study on choosing the proper retaining wall solution for a specific case study you can check out the following pdf !

    No comments:

    Post a Comment

    Popular Posts